Ozistar Controller

Using and Cautions:

1 Connect the PWM dimmer(3PIN DIM OUT) to daisy chain dimming control box with factory supply wire(3PIN DIM IN). Note: The 3pin dimming input wire also accept 0-10V dimmer to connect with factory supply connection wire.

2 The dimming controller come with MASTER/SLAVE mode,using factory supply PWM remote controller,one controller can control multiple LED lights with factory supply daisy chain dimming control box/wires.

Using the factory supply PWM remote controller without factory supply daisy chain dimming control box.You need an extra 12V DC driver to power on PWM dimmer.

4 Make sure to use daisy chain dimming control function with factory supply daisy chain connection wires

5 The manual knob on the daisy chain dimming control box can dimming control/daisy chain dimming control the LED lights. 6 Do not control the LED lights by PWM dimmer,0-10V dimmer and Manual Knob at the same time.

SETTING STEPS:

1.Press to turn on/off the LED fixtures. >Main interface with ENVIRONMENT TEMPERATURE (TEM) /LOCAL TIME (T) /BRIGHTNESS(CHA-Channel A)

2.Please set local time first before using dimming function: press"TIME" for local time setting. Step1:Press TIME to enter into time setting interface. Step2:Press "OK" to select item,press for HOUR / MINUTE toggle Step3:Press" + - " to change number and press "OK" to save and "Back" back to main interface.

3.Customization settings: The dimmer can set/save 2 customized settings in the system. Step1:Press"CUS" to enter into customization settings(INTERFACE 3). Step2:Press "OK" to select,press for CUSTOM 1/CUSTOM 2 toggle Step3:Press"OK"to select CUSTOM1 or CUSTOM2,press"OK" again to enter into setting interface(INTERFACE 4) Step4:Press"OK" to start setting,press directional key UP/DOWN/LEFT/RIGHT to select BRT(BRIGHTNESS) and TIME(INTERFACE 4).press " + - " to change the number. Step5:When all customization setting done,press"OK" to save and auto run the "CUSTOM" settings(INTERFACE 5) Note:Press"Back" can cancel the custom setting and back to main interface.

4.Press "PRE" to select factory preset programs,there are 2 preset programs in the system,press the directional key "UP/DOWN to select "PRESET1" or "PRESET2",once selected,press "OK" to save and run the program.